Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A337994
  1. Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

  1. Disengage the ventilation hose clamp.



    A337996
  1. Disconnect the mass air flow meter sub-assembly connector.

  1. Disengage the wire harness clamp.



    A337995
  1. Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.

  1. Disengage the 2 air cleaner cap clamps and 2 guides.



    A337997
  1. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.



3. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
  1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.



4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A338951
  1. Disconnect the wire harness clamp.

  1. Remove the 2 bolts and air cleaner case sub-assembly.



5. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A315230E01
  1. Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.
    Text in Illustration 
    *1
    Engine Under Cover LH
    *a
    Hose

  1. Loosen the radiator drain cock plug.



    A338632E01
  1. Remove the radiator cap sub-assembly. Then drain the engine coolant.
    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  1. Disconnect the hose from the radiator drain cock.



6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A338019
  1. Disconnect the engine coolant temperature sensor connector.



    A338020E01
  1. Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.
    Text in Illustration 
    *1
    Engine Coolant Temperature Sensor
    *2
    Gasket

    SST
    09817-33191  

    NOTICE:
    If the engine coolant temperature sensor has been struck or dropped, replace it.

  1. Remove the gasket from the engine coolant temperature sensor.