Home › Engine / Hybrid System · 6AR-FSE › ENGINE CONTROL › ENGINE OIL TEMPERATURE SENSOR

ENGINE OIL TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE OIL TEMPERATURE SENSOR


    A171057E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Engine Oil Temperature Sensor)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    30°C (86°F)
    2.465 to 3.213 kΩ

    NOTICE:
    If checking the engine oil temperature sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the engine oil temperature sensor.

    If the result is not as specified, replace the engine oil temperature sensor.