Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › ENGINE OIL TEMPERATURE SENSOR

ENGINE OIL TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
  1. Remove the 3 screws and front wheel opening extension pad RH.



2. REMOVE ENGINE UNDER COVER RH
  1. Remove the 3 screws, 3 clips and engine under cover RH.



3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
  1. Remove the 3 screws and front wheel opening extension pad LH.



4. REMOVE ENGINE UNDER COVER LH
  1. Remove the 3 screws, 2 clips and engine under cover LH.



5. DRAIN ENGINE OIL
  1. Remove the oil filler cap sub-assembly.

  1. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

  1. Clean the oil pan drain plug.

  1. Install a new gasket to the oil pan drain plug.

  1. Install the oil pan drain plug.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



6. REMOVE ENGINE OIL TEMPERATURE SENSOR


    A338023
  1. Disconnect the engine oil temperature sensor connector.



    A338024E01
  1. Using SST, remove the engine oil temperature sensor from the water inlet housing sub-assembly.
    Text in Illustration 
    *1
    Engine Oil Temperature Sensor
    *2
    Gasket

    SST
    09817-33191  

    NOTICE:
    If the engine oil temperature sensor has been struck or dropped, replace it.

  1. Remove the gasket from the engine oil temperature sensor.