Home › Engine / Hybrid System · 6AR-FSE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSPECTION

for Preparation Click here



1. INSPECT KNOCK CONTROL SENSOR


    A294030E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Knock Control Sensor)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    25°C (77°F)
    120 to 280 kΩ

    If the result is not as specified, replace the knock control sensor.