Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A209579
  1. Remove the 4 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).



2. REMOVE AIR FUEL RATIO SENSOR


    A338030
  1. Disengage the 3 wire harness clamps.



    A338570E01
  1. Disconnect the air fuel ratio sensor connector.

  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold.

    SST
    09224-00011  

    NOTICE:
    If the air fuel ratio sensor has been struck or dropped, replace it.