Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

TELEMATICS SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Telematics / Data List.

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    VIN
    VIN registered to the telematics transceiver/17 digits
    Vehicle VIN displayed
    -
    Unsent Emergency Call Number
    Number of times an emergency call has failed/Min.: 0, Max.: 255
    0
    -
    Activation Status
    Telematics transceiver activation status/Shipping(Disable), Shipping(Enable), Full Services, Full Services & F&I Service, eCall only
    eCall only
    -
    Backup Battery Status
    Mobilephone battery replacement flag/Normal or Replace
    Normal
    -
    Number of Trouble Codes
    The number of the DTC which is currently output/Min.: 0, Max.: 255
    Number of stored DTCs displayed
    -

  5. According to the display on the GTS, read the "Data List".


ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Telematics / Active Test.

  5. According to the display on the GTS, perform the Active Test.

    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Beep
    Operate front No. 2 speaker assembly RH and front No. 1 speaker assembly RH*
    OFF, ON
    -

    1. *: for 6 Speakers