Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

DTC    B1583    GPS Signal Unreceived

for Preparation Click here


DESCRIPTION

This DTC is stored when GNSS satellite signals is not received for 30 km.

DTC No.
DTC Detection Condition
Trouble Area
B1583
GNSS signals are not received for 30 km.
  1. Telematics transceiver
  2. Telephone antenna assembly
  3. Wire harness or connector

INSPECTION PROCEDURE

NOTICE:
initialization, registration or calibration may be needed. Refer to Registration for Telematics System (Click here).

1.MOVE VEHICLE
  1. If the vehicle is outside the communication service area, move the vehicle into a communication service area, wait for a while and perform the operation again.


NEXT


2.CHECK DTC
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and wait for 20 seconds.

  1. Turn the GTS on.

  1. Check for DTCs and check that no DTCs are output (Click here).

    OK:
    No DTCs are output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK OPTIONAL COMPONENTS
  1. Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.

    Result:

    Result
    Proceed to
    Optional components are not installed
    A
    Optional components are installed
    B

    NOTICE:
    Do not remove optional components without the permission of the customer.



B
REPLACE OPTIONAL COMPONENTS
A


4.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    Result:

    Result
    Proceed to
    No DTCs are output.
    A
    DTC B1583 is output. (w/ Navigation System)
    B
    DTC B1583 is output. (w/o Navigation System)
    C



B
Go to step 5

C
Go to step 7
A

END 

5.CHECK HARNESS AND CONNECTOR
Click here


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.INSPECT ANTENNA DIVIDER
Click here


NG
REPLACE ANTENNA DIVIDER (Click here)
OK


Go to step 8

7.CHECK HARNESS AND CONNECTOR
Click here


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


8.REPLACE TELEPHONE ANTENNA ASSEMBLY
  1. Replace the telephone antenna assembly with a new or known good one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output.

    OK:
    No DTCs are output.



NG
Go to step 9
OK

END 

9.REPLACE TELEMATICS TRANSCEIVER
  1. Replace the telematics transceiver with a new one (Click here).


NEXT

PERFORM REGISTRATION (Click here)