Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

DTC    B1573    Disconnect/Short in Telephone Antenna Circuit

DTC    B15CB    Telephone Antenna Disconnected

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the telephone antenna assembly.

DTC No.
DTC Detection Condition
Trouble Area
B1573
Telephone antenna assembly impedance (Ω) is lower than the malfunction threshold for 20 seconds when the ignition switch is ON. (Short circuit)
  1. Telematics transceiver
  2. Telephone antenna assembly
  3. Wire harness or connector
B15CB
Telephone antenna assembly impedance (Ω) is higher than the malfunction threshold for 20 seconds when the ignition switch is ON. (Open circuit)
  1. Telematics transceiver
  2. Telephone antenna assembly
  3. Wire harness or connector

WIRING DIAGRAM


E360069E05


INSPECTION PROCEDURE

NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System (Click here).

1.CHECK DTC
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and wait for 20 seconds.

  1. Turn the GTS on.

  1. Check for DTCs and check that no DTCs are output (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.INSPECT TELEPHONE ANTENNA ASSEMBLY
  1. Remove the telephone antenna assembly (Click here).



    B278874E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 3a
    Always
    4 to 11 kΩ

    Text in Illustration 
    *a
    Component without harness connected
    (Telephone Antenna Assembly)



NG
REPLACE TELEPHONE ANTENNA ASSEMBLY (Click here)
OK


3.INSPECT HARNESS AND CONNECTOR
  1. Disconnect the O47 telephone antenna assembly connector.

  1. Disconnect the O49 telematics transceiver connector.



    E170182E03
    E258653E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O47-3 (TEL1) - O49-1 (TEL2)
    Always
    Below 1 Ω
    O47-3a - O49-1a
    Always
    Below 1 Ω
    O47-3 (TEL1) or O49-1 (TEL2) - Body ground
    Always
    10 kΩ or higher
    O47-3a or O49-1a - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Telephone Antenna Assembly)
    *b
    Front view of wire harness connector
    (to Telematics Transceiver)



NG
REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE TELEMATICS TRANSCEIVER
  1. Replace the telematics transceiver with a new one (Click here).


NEXT

PERFORM REGISTRATION (Click here)