Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

DTC    B15C4    SRS Communication Error

for Preparation Click here


DESCRIPTION

If the telematics transceiver detects an error in communication between itself and the airbag sensor assembly as a result of a self check, this DTC will be stored.

DTC No.
DTC Detection Condition
Trouble Area
B15C4
The telematics transceiver detects an error in signals from the airbag sensor assembly when ignition switch is ON.
  1. Telematics transceiver
  2. Airbag sensor assembly
  3. Wire harness or connector
  4. Airbag system

WIRING DIAGRAM


E342824E01


INSPECTION PROCEDURE

NOTICE:
  1. Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System (Click here).
  2. This vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (Click here).

1.CHECK DTC (AIRBAG SYSTEM)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and wait for 20 seconds.

  1. Turn the GTS on.

  1. Check for DTCs and check that no DTCs are output (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

GO TO AIRBAG SYSTEM (Click here)  

2.INSPECT TELEMATICS TRANSCEIVER


    B240640E23
  1. Measure the voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    24 (GSW) - Body ground
    Ignition switch ON
    8.0 to 16 V

    Reference Waveform:
    Item
    Condition
    Tester connection
    I218-24 (GSW) - Body ground
    Tool setting
    5.0 V/DIV., 20 ms/DIV.
    Vehicle condition
    Ignition switch ON

    Text in Illustration 
    *a
    Component with harness connected
    (Telematics Transceiver)



NG
Go to step 4
OK


3.REPLACE TELEMATICS TRANSCEIVER
  1. Replace the telematics transceiver with a new one (Click here).


NEXT

PERFORM REGISTRATION (Click here)  

4.CHECK HARNESS AND CONNECTOR
  1. Disconnect the I218 telematics transceiver connector.

  1. Disconnect the I47 airbag sensor assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I218-24 (GSW) - I47-24 (GSW3)
    Always
    Below 1 Ω
    I218-24 (GSW) or I47-24 (GSW3) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIRBAG SENSOR ASSEMBLY (Click here)