DTC B15C5 Emergency Switch Error (Open or Short) |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15C5 | Open or short circuit in the manual (SOS) switch is detected. |
|

| 1.CHECK DTC |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch ON and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output (Click here).
|
| ||||
| OK | ||
| ||
| 2.INSPECT ROOF CONSOLE BOX ASSEMBLY (MANUAL (SOS) SWITCH) |
Remove the roof console box assembly (manual (SOS) switch) (Click here).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 13 (SIG1) - 9 (GND3) | Manual (SOS) switch not pressed | 392 to 432 Ω |
| 13 (SIG1) - 9 (GND3) | Manual (SOS) switch pressed | 78 to 86 Ω |
| *a | Component without harness connected (Roof Console Box Assembly (Manual (SOS) Switch) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX ASSEMBLY) |
Disconnect the I218 telematics transceiver connector.
Disconnect the S7 roof console box assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I218-27 (SIG1) - S7-13 (SIG1) | Always | Below 1 Ω |
| I218-26 (SIG-) - S7-9 (GND3) | Always | Below 1 Ω |
| I218-27 (SIG1) or S7-13 (SIG1) - Body ground | Always | 10 kΩ or higher |
| I218-26 (SIG-) or S7-9 (GND3) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE TELEMATICS TRANSCEIVER |
Replace the telematics transceiver with a new one (Click here).
| NEXT | ||
| ||