Home › Vehicle Exterior › BODY PANEL › FRONT DOOR OUTER PANEL
BM33A0E _01 Vehicle Exterior _067228 BODY PANEL _0327723 FRONT DOOR OUTER PANEL F

BODY PANEL  FRONT DOOR OUTER PANEL  ASSEMBLY REPLACEMENT  


K140657

REMOVAL


Symbol Meaning
K108818

Remove Weld Points

a.

Before removing the outer panel, mark the installation position with tape.

HINT:

Before removing the outer panel, establish its exact position in relation to the window frame using a reference marker, etc.


K140318C01
4.99,1.073 5.323,0.792 5.323,0.792 5.521,0.792 false 5.563,0.698 5.875,0.854 0.313,0.156 10 false *a 4.417,1.188 4.729,1.344 0.313,0.156 10 false *b
*a Positioning Tape *b Installation Position



b.

After grinding off the hemming location, remove the outer panel.

K140319C01
6.5,3.177 6.333,3.177 6.333,3.177 6.208,2.896 false 6.583,3.094 6.896,3.25 0.313,0.156 10 false *a 6.031,0.708 6.344,0.865 0.313,0.156 10 false *b
*a Disc Sander *b Hemming Location




INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108833

Spot MIG Weld
K108834

Body Sealer

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Before temporarily installing the new parts, apply body sealer to the backside of the new parts.

NOTICE:

Do not close the drain hole.


HINT:

Apply sealer evenly about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement to make contact.


K140321C01
2.333,3.448 2.063,3.448 2.063,3.448 1.771,3.094 false 2.375,3.354 2.688,3.51 0.313,0.156 10 false *1 6.26,3.156 6.573,3.313 0.313,0.156 10 false *a 5.135,1.417 5.448,1.573 0.313,0.156 10 false *b
*1 FRONT DOOR PANEL OUTER - -
*a Drain Hole *b 10 mm (0.39 in.)



c.

Bend the flange hem with a wooden hammer and dolly.

HINT:

Bend the panel gradually so as not to distort it.


K140320C01
3.917,0.906 4.365,0.521 4.365,0.521 4.635,0.521 false 4.667,0.438 4.979,0.594 0.313,0.156 10 false *a 6.333,3.906 6.646,4.063 0.313,0.156 10 false *b 6.427,5.094 6.74,5.25 0.313,0.156 10 false *c 5.115,5.396 5.427,5.552 0.313,0.156 10 false *d
*a Positioning Tape *b Cloth Tape
*c Dolly *d Wooden Hammer



d.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.