Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
| *1 | LUGGAGE COMPARTMENT DOOR EMBLEM | *2 | NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE |
| *3 | NO. 3 LUGGAGE COMPARTMENT DOOR PLATE | *4 | NO. 7 LUGGAGE COMPARTMENT DOOR NAME PLATE |
| ● | Non-reusable part | - | - |
INSTALL LUGGAGE COMPARTMENT DOOR EMBLEM
Engage the 2 pins and install the luggage compartment door emblem as shown in the illustration.
INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
Engage the 10 pins and install the No. 2 luggage compartment door name plate as shown in the illustration.
INSTALL NO. 3 LUGGAGE COMPARTMENT DOOR PLATE
Install the No. 3 luggage compartment door plate as shown in the illustration.
| *a | Profile of Luggage Compartment Door Panel | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 20.4 mm (0.803 in.) | B | 19.5 mm (0.768 in.) |
| C | 10.6 mm (0.417 in.) | - | - |
Press the No. 3 luggage compartment door plate firmly to install it.
INSTALL NO. 7 LUGGAGE COMPARTMENT DOOR NAME PLATE
Install the No. 7 luggage compartment door name plate as shown in the illustration.
| *a | Profile of Luggage Compartment Door Panel | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 8.7 mm (0.343 in.) | B | 13.9 mm (0.547 in.) |
| C | 24.1 mm (0.949 in.) | - | - |
Press the No. 7 luggage compartment door name plate firmly to install it.