Home › Vehicle Exterior › BODY PANEL › FRONT BODY PILLAR(for Type B)
BM33A0E _01 Vehicle Exterior _067228 BODY PANEL _0327822 FRONT BODY PILLAR(for Type B) F

BODY PANEL  FRONT BODY PILLAR(for Type B)  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K140653

With the cowl top side upper panel assembly removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts

K143828C01
3.219,2.344 3.531,2.5 0.313,0.156 10 false *a
*a 60 mm (2.36 in.) - -
K111603

Laser Screw Welding - -


K140265

K140266

a.

When replace only the outer panel, please cut off a necessary range depending on a damage range.

i.

Carefully cut the outer panel so not to damage the reinforcement.


ii.

Make sure that butt welding does not heat-affect the reinforcement when welding the outer panel.




INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108831

Butt Weld
K108834

Body Sealer

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


c.

Before installing a new part, apply body sealer.

HINT:

Apply body sealer in an even, continuous bead.


K140267

K143829C01
2.594,3.438 3.719,2.99 3.719,2.99 4.104,2.99 false 4.177,2.917 4.49,3.073 0.313,0.156 10 false *1
*1 FRONT BODY PILLAR UPPER OUTER - -
K111603

Laser Screw Welding - -


K140269


d.

After welding, apply the foamed sealing material to the corresponding parts. (See the painting/coating)


e.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


f.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.