Refer to the TOYOTA Repair Manual for each work procedure.
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
| Replacement Part | Necessary Procedure | Effect/Inoperative Function when Necessary Procedures not Performed | Note | |
|---|---|---|---|---|
|
*1: When the ECM is replaced with a new one, reset memory is unnecessary. *2: The vehicle height changes because of suspension or tire replacement. *3: w/ Smart Entry and Start System *4: w/o Smart Entry and Start System *5: w/ Occupant Classification System *6: for 3 Zone Type |
||||
| ECM | Vehicle Identification Number (VIN) registration | MIL comes on | - | |
| Perform code registration (Immobiliser system) | Engine start function | See Service Bulletin for the registration method. | ||
for 2AR-FE
·
Throttle body with motor assembly ·
Engine assembly ·
Cylinder head sub-assembly ·
Camshaft (for intake or exhaust camshaft) ·
Camshaft timing gear assembly ·
Camshaft timing exhaust gear assembly ·
Piston or piston ring ·
Mass air flow meter sub-assembly ·
Fuel injector assembly ·
Fuel pump ·
Air fuel ratio sensor ·
Engine coolant temperature sensor ·
Spark plug ·
Ignition coil assembly ·
Air intake system parts ·
Exhaust system parts ·
Knock control sensor |
Inspection after repair | ·
Poor idle, etc. ·
Engine start function, etc. |
- | |
for A25A-FKS
·
Throttle body with motor assembly ·
Cam timing control motor with EDU assembly ·
Removal and installation of a cam timing control motor with EDU assembly ·
Camshaft timing gear assembly ·
Removal and installation of a camshaft timing gear assembly ·
Engine assembly ·
Cylinder head sub-assembly ·
Camshaft (for intake or exhaust camshaft) ·
Camshaft timing exhaust gear assembly ·
Piston or piston ring ·
Mass air flow meter sub-assembly ·
Port fuel injector assembly ·
Direct fuel injector assembly ·
Fuel pump (for low pressure side) ·
Fuel pump assembly (for high pressure side) ·
Fuel pressure sensor (fuel delivery pipe with sensor sub-assembly) (for low pressure side) ·
Fuel pressure sensor (for high pressure side) ·
Air fuel ratio sensor (sensor 1) ·
Air fuel ratio sensor (sensor 2) ·
Engine coolant temperature sensor ·
Spark plug ·
Ignition coil assembly ·
EGR valve assembly ·
Air intake system parts ·
Exhaust system parts ·
Knock control sensor |
Inspection after repair | ·
Poor idle, etc. ·
Engine start function, etc. |
- | |
for 2GR-FKS
·
Throttle body with motor assembly ·
Engine assembly ·
Cylinder head sub-assembly ·
Camshaft (for intake or exhaust camshaft) ·
Camshaft timing gear assembly ·
Camshaft timing exhaust gear assembly ·
Piston or piston ring ·
Mass air flow meter sub-assembly ·
Fuel injector assembly (for port injection) ·
Fuel injector assembly (for direct injection) ·
Fuel pump (for low pressure side) ·
Fuel pump assembly (for high pressure side) ·
Fuel pressure sensor (for low pressure side) ·
Fuel pressure sensor (for high pressure side) ·
Air fuel ratio sensor ·
Engine coolant temperature sensor ·
Spark plug ·
Ignition coil assembly ·
Air intake system parts ·
Exhaust system parts ·
Knock control sensor |
Inspection after repair | ·
Poor idle, etc. ·
Engine start function, etc. |
- | |
| Millimeter wave radar sensor assembly | Adjust millimeter wave radar sensor assembly | ·
Dynamic Radar Cruise Control System ·
Forward Recognition Camera System ·
Lane Departure Alert System (w/ Steering Control) ·
Pre-collision System |
- | |
·
Forward recognition camera ·
Windshield glass |
Adjust forward recognition camera | ·
Dynamic Radar Cruise Control System ·
Forward Recognition Camera System ·
Lane Departure Alert System (w/ Steering Control) ·
Pre-collision System ·
Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System) ·
Road Sign Assist System |
- | |
| Automatic transaxle assembly | 1.
Reset memory 2.
Input transaxle compensation code into ECM 3.
Perform road test to allow ECM to learn |
·
Large shift shock ·
Deterioration of fuel efficiency |
- | |
·
Transmission valve body assembly ·
Solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve |
1.
Reset memory 2.
Reset transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| ECM
(If possible, read the transaxle compensation code from the previous ECM) |
1.
Reset memory*1 2.
Transfer transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| ECM
(If impossible, read the transaxle compensation code from the previous ECM) |
1.
Reset memory*1 2.
Reset transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| Automatic transaxle assembly | 1.
Reset memory 2.
Input transaxle compensation code into ECM 3.
Perform road test to allow ECM to learn |
·
Large shift shock ·
Deterioration of fuel efficiency |
- | |
·
Transmission valve body assembly ·
Solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve |
1.
Reset memory 2.
Reset transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| ECM
(If possible, read the transaxle compensation code from the previous ECM) |
1.
Reset memory*1 2.
Transfer transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| ECM
(If impossible, read the transaxle compensation code from the previous ECM) |
1.
Reset memory*1 2.
Reset transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| Automatic transaxle assembly | Perform the following procedures in the order shown:
1.
Reset Memory 2.
Input transaxle compensation code into ECM 3.
Perform road test to allow ECM to learn |
·
Large shift shock ·
The deterioration of fuel efficiency |
- | |
·
Valve body assembly ·
Shift solenoid valve SL3 and/or SL4 |
Perform the following procedures in the order shown:
1.
Reset Memory 2.
Reset transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| Shift solenoid valve SL1 and/or SL2 | Perform road test to allow ECM to learn | |||
| ECM (If possible, read the transaxle compensation code from the previous ECM) | Possible | Perform the following procedures in the order shown:
1.
Reset Memory 2.
Transfer transaxle compensation code 3.
Perform road test to allow ECM to learn |
||
| Impossible | Perform the following procedures in the order shown:
1.
Reset Memory 2.
Reset transaxle compensation code 3.
Perform road test to allow ECM to learn |
|||
| Automatic transaxle fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. | - | |
·
Tire pressure warning ECU and receiver ·
Tire pressure warning valve and transmitter |
·
Register Transmitter ID ·
Initialize tire pressure warning system |
·
When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates. ·
Tire pressure warning function |
- | |
·
Skid control ECU (brake actuator assembly) ·
Yaw rate and acceleration sensor (airbag sensor assembly) |
Perform system variant learning and acceleration sensor zero point calibration. | ·
VSC disabled or malfunctioning ·
DTCs are output ·
Slip indicator light illuminated ·
ABS warning light illuminated |
- | |
| Skid control ECU (brake actuator assembly) | Operate the electric parking brake switch (electric parking brake switch assembly) | Parking brake indicator light (red) blinks when the engine switch is first turned on (IG) | - | |
| Rack and pinion power steering gear assembly | ·
Perform torque sensor zero point calibration ·
Assist Map Writing |
·
DTCs are output ·
Steering effort different between turning steering wheel left and right ·
EPS warning light illuminates |
- | |
·
Clearance warning ECU assembly ·
Ultrasonic sensor |
Adjust TOYOTA parking assist-sensor system | TOYOTA Parking Assist-sensor System | - | |
| Steering sensor | ·
Steering angle neutral point (Initialize parking assist monitor system) ·
Steering angle setting |
Parking Assist Monitor System | - | |
| Suspension, tires*2 | Rear television camera assembly optical axis (Back camera position setting) | |||
| Rear television camera assembly | ·
Parking assist monitor system initialization ·
Rear television camera assembly optical axis (Back camera position setting) |
|||
| Blind spot monitor sensor | Blind spot monitor beam axis adjustment | Blind Spot Monitor System | - | |
·
Certification ECU (smart key ECU assembly)*3 ·
Steering lock ECU (steering lock actuator or upper bracket assembly)*3 ·
Electrical key transmitter sub-assembly*3 ·
ECM*3 ·
Main body ECU (multiplex network body ECU)*3 ·
ID code box (immobiliser code ECU)*7 |
Perform code registration (Immobiliser function) | ·
Wireless door lock control system ·
Smart Entry and Start System (for Entry Function) ·
Smart Entry and Start System (for Start Function) ·
Steering lock function |
See Service Bulletin for the registration method. | |
·
Transponder key ECU assembly*4 ·
Door control transmitter module set sub-assembly*4 ·
ECM*4 |
Perform code registration (Immobiliser system) | ·
Wireless Door Lock Control System ·
Engine start |
See Service Bulletin for the registration method. | |
·
Occupant detection ECU ·
Front passenger seat*5 |
Zero point calibration (Occupant classification system) | ·
Occupant classification system ·
Passenger airbag ON/OFF indicator ·
Airbag system (Front passenger side) ·
Seat belt warning system (Front passenger) |
- | |
·
Position control ECU assembly (driver seat) ·
Front seatback frame sub-assembly (driver seat) ·
Front seat adjuster assembly (driver seat) |
Initialize position control ECU | Front Power Seat Control System | - | |
·
No. 1 air conditioning radiator damper servo sub-assembly ·
No. 2 air conditioning radiator damper servo sub-assembly ·
No. 3 air conditioning radiator damper servo sub-assembly*6 ·
No. 1 blower damper servo sub-assembly ·
Air conditioning amplifier assembly |
Initialization servo motor (Air conditioning system (for Automatic Air Conditioning System)) | DTCs are output | - | |
·
No. 1 air conditioning radiator damper servo sub-assembly ·
No. 2 air conditioning radiator damper servo sub-assembly ·
No. 1 blower damper servo sub-assembly ·
Air conditioning amplifier assembly |
Initialization servo motor (Air conditioning system (for Manual Air Conditioning System)) | DTCs are output | - | |
·
Door window regulator sub-assembly ·
Power window regulator motor sub-assembly ·
Door glass ·
Door glass run |
Initialize power window control system | ·
Auto up and down function ·
Jam protection function ·
Remote control function ·
Key-linked function ·
Wireless transmitter-linked function ·
Key-off operation function ·
Catch protection function ·
Window open warning function |
- | |
·
Sliding roof ECU (sliding roof drive gear) ·
Sliding roof glass sub-assembly ·
Slide roof drive cable sub-assembly ·
Slide roof drive gear sub-assembly |
Initialize sliding roof system | ·
Auto operation function ·
Jam protection function ·
Key-off operation function ·
Key-linked function ·
Wireless transmitter linked function ·
Sliding roof open warning function |
- | |
·
Sliding roof ECU (sliding roof drive gear) ·
Slide roof housing panel ·
Slide roof rail sub-assembly ·
Sliding roof glass sub-assembly |
Initialize panoramic moon roof system (for Sliding Roof) | ·
Auto operation function ·
Jam protection function ·
Key-off operation function ·
Key-linked function ·
Wireless transmitter linked function ·
Sliding roof open warning function |
- | |
·
Roof sunshade ECU (sliding roof drive gear assembly) ·
Sunshade trim sub-assembly ·
Slide roof rail sub-assembly |
Initialize panoramic moon roof system (for Roof Sunshade) | ·
Auto operation function ·
Jam protection function ·
Key-off operation function |
||
| Headlight ECU sub-assembly LH | ·
Synchronize the vehicle information ·
Perform headlight ECU sub-assembly LH initialization |
Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System) | - | |
·
Rear height control sensor sub-assembly LH ·
Suspension, tires*2 |
Perform headlight ECU sub-assembly LH initialization | |||