Home › Vehicle Exterior › BODY PANEL › ROCKER OUTER PANEL › from 2018.04
BM33A0E _01 Vehicle Exterior _067228 BODY PANEL _0327742 ROCKER OUTER PANEL F

BODY PANEL  ROCKER OUTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K140659

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts

K145528

K140327C01
5.167,2.115 5.479,2.271 0.313,0.156 10 false *a
*a 100 mm (3.94 in.) - -


a.

When replace only the outer panel, please cut off a necessary range depending on a damage range.

i.

Carefully cut the outer panel so not to damage the reinforcement.


ii.

Make sure that butt welding does not heat-affect the reinforcement when welding the outer panel.




INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108831

Butt Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

K145529C01
2.938,4.688 2.688,4.688 2.688,4.688 2.385,3.865 false 2.99,4.604 3.302,4.76 0.313,0.156 10 false *1
*1 ROCKER PANEL OUTER - -



c.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


d.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.