Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2017.09–2017.12
NM33A0E _57 Power Source / Network _067341 NETWORKING _0328400 CAN COMMUNICATION SYSTEM CO CONTROL F

NETWORKING  CAN COMMUNICATION SYSTEM  CONTROL  CAN COMMUNICATION CONTROL  


FUNCTION


CAN Connection Components

*1: Models with Toyota safety sense

*2: Models with blind spot monitor system

*3: Models with parking assist monitor system

*4: Models with TOYOTA parking assist-sensor system

*5: Models with radio and display receiver assembly

*6: Models with occupant classification system

*7: Models with tire pressure warning system

*8: Models with seat position memory system

*9: Models with smart entry and start system

*10: Models with headup display system

*11: Models with power tilt and power telescopic system

Central Gateway ECU (Network Gateway ECU) Forward Recognition Camera*1
Millimeter Wave Radar Sensor Assembly*1 Blind Spot Monitor Sensor RH*2
Rear Television Camera Assembly*3 Clearance Warning ECU Assembly*4
ECM Radio and Display Receiver Assembly*5
Occupant Detection ECU*6 Tire Pressure Warning ECU and Receiver*7
Power Steering ECU (Rack and Pinion Power Steering Gear Assembly) Skid Control ECU (Brake Actuator Assembly)
Steering Sensor Airbag Sensor Assembly
Headlight ECU Sub-assembly RH Outer Mirror Control ECU Assembly RH*8
Position Control ECU Assembly RH*8 Outer Mirror Control ECU Assembly LH*8
Air Conditioning Amplifier Assembly Main Body ECU (Multiplex Network Body ECU)
Certification ECU (Smart Key ECU Assembly)*9 Headup Display (Meter Mirror Sub-assembly)*10
Headlight ECU Sub-assembly LH Multiplex Tilt and Telescopic ECU*11
Combination Meter Assembly -


DIAGNOSIS


a.

If a malfunction occurs on a CAN communication bus, ECUs that are connected to the CAN communication bus store Diagnostic Trouble Codes (DTCs) in memory.


b.

The 5-digit DTCs can be read by connecting the Global TechStream (GTS) to the DLC3.


c.

For details, refer to the Repair Manual.