Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
NM33A0E _52 Drivetrain _065980 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0328979 AUTOMATIC TRANSAXLE SYSTEM DE DETAILS F

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  DETAILS  TRANSMISSION REVOLUTION SENSOR  


CONSTRUCTION


a.

The UA80E automatic transaxle uses a transmission revolution sensor (NT), transmission revolution sensor (NC). Thus, the ECM can detect the timing of the shifting of the gears and appropriately control the engine torque and hydraulic pressure in response to the various conditions.


b.

The transmission revolution sensor (NT) detects the input speed of the transaxle. The C2 clutch drum is used as the timing rotor for this sensor.


c.

The transmission revolution sensor (NC) detects the output speed of the transaxle. The counter drive gear is used as the timing rotor for this sensor.


d.

A Hall type revolution sensor consists of a magnet and a Hall IC. The Hall IC converts the changes in the magnetic flux density that occur through the rotation of the timing rotor into an electric signal, and outputs the signal to the ECM.

X134150C01
2.083,2.583 2.25,2.583 2.25,2.583 2.375,1.875 true 6.167,0.417 6,0.417 6,0.417 5.625,1.375 true 6.583,1.167 6.417,1.167 6.417,1.167 5.792,1.583 true 1.885,2.479 2.198,2.677 0.313,0.198 10 false *1 6.208,0.281 6.521,0.479 0.313,0.198 10 false *1 6.646,1.042 6.958,1.24 0.313,0.198 10 false *2
*1 Transmission Revolution Sensor (NC) *2 Transmission Revolution Sensor (NT)