Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM
NM33A0E _54 Brake _067417 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0329247 BRAKE CONTROL SYSTEM CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  CONTROL  SECONDARY COLLISION BRAKE  


SYSTEM CONTROL


a.

The secondary collision brake system lessens damage from a secondary collision by controlling the automatic brakes and stop light illumination after a collision occurs.


b.

When the airbag sensor assembly detects a collision and operates the airbags, it sends a collision detection signal to the skid control ECU. When the skid control ECU receives a collision detection signal, it determines that operation can start, operates the brake actuator and performs braking. Simultaneously, the skid control ECU sends a stop light illumination request to the stop light switch assembly, illuminating the stop lights.

X137264E06
2.875,0.344 3.833,0.833 0.958,0.49 10 false Brake Actuator Assembly 2.958,2.229 3.76,2.688 0.802,0.458 10 false Skid Control ECU 0.396,1.021 2.135,1.427 1.74,0.406 10 false Airbag Sensor Assembly 0.406,1.854 2.094,2.177 1.688,0.323 10 false Network Gateway ECU 0.979,2.802 1.531,3.031 0.552,0.229 10 false ECM 0.24,3.5 2.333,3.833 2.094,0.333 10 false Combination Meter Assembly 0.677,4.156 2.771,4.49 2.094,0.333 10 false : CAN Communication Line 5.198,2.323 6.979,2.604 1.781,0.281 10 false Stop Light Switch Assembly 5.719,3.406 6.5,3.688 0.781,0.281 10 false Stop Light 5.458,1.229 6.76,1.5 1.302,0.271 10 false Speed Sensors (4) 4.104,1.438 4.969,1.854 0.865,0.417 10 false Wheel Speed Signal 4.073,2.531 4.99,3.594 0.917,1.063 10 false Stop Light Illumination Request Signal 6.156,2.76 6.875,3.333 0.719,0.573 10 false Stop Lights Illumination


c.

Secondary Collision Brake Operation Start Condition

i.

When a collision detection signal is received from the airbag sensor assembly while the vehicle speed is approximately 10 km/h or more, the secondary collision brake starts operating.

HINT:

When a system malfunction is displayed on the multi-information display or the system is in test mode or maintenance mode, the secondary collision brake is prohibited from operating.




d.

Secondary Collision Brake Operation Cancellation Condition

i.

If one of the following conditions is detected, operation of the secondary collision brake is canceled.

Secondary Collision Brake Operation Cancellation Condition
·

The vehicle speed is below approximately 10 km/h.

·

Operation continues for a certain period of time.

·

After operating, the accelerator pedal is depressed a certain amount or more.