Home › Engine / Hybrid System › 2AR-FE (ENGINE MECHANICAL) › ENGINE UNIT › 2017.09–2021.02
NM33A0E _51 Engine / Hybrid System _067507 2AR-FE ENGINE MECHANICAL _0330095 ENGINE UNIT DE DETAILS F

2AR-FE ENGINE MECHANICAL  ENGINE UNIT  DETAILS  CRANKSHAFT BEARING  


CONSTRUCTION


a.

The crankshaft bearings are reduced in width to reduce friction.


b.

The lining surfaces of the crankshaft bearings are micro-grooved to achieve an optimal amount of oil clearance. As a result, cold-engine cranking performance has been improved and engine vibration has been reduced.


c.

The oil groove on the crankshaft bearing is made eccentric to reduce the amount of oil leakage from the bearing. This enables the capacity of the oil pump to be reduced in order to reduce parasitic losses.

W100800C03
3.146,0.906 3.146,0.188 3.146,0.188 3.25,0.188 true 2.792,1.104 2.333,0.646 2.333,0.646 2.135,0.646 true 3.323,1.948 3.323,2.344 true 2.427,4.229 2.427,4.604 true 5.125,4.208 5.125,4.563 true 3.292,0.104 4.042,0.458 0.75,0.354 10 false *1 1.958,0.531 2.667,0.719 0.708,0.188 10 false *a 1.802,1.969 2.719,2.125 0.917,0.156 10 false *b 3.271,2.385 3.469,2.563 0.198,0.177 10 false *2 4.531,1.146 4.708,1.302 0.177,0.156 10 false *e 4.188,1.375 4.552,1.531 0.365,0.156 10 false *d 4.896,1.365 5.083,1.521 0.188,0.156 10 false *d 2.396,4.625 2.573,4.781 0.177,0.156 10 false *f 2.469,5.25 2.667,5.396 0.198,0.146 10 false *h 4.51,1.823 4.729,2.01 0.219,0.188 10 false *c 5.063,4.573 5.281,4.938 0.219,0.365 10 false *g 5.271,5.24 5.438,5.406 0.167,0.167 10 false *i
*1 Upper Main Bearing *2 Lower Main Bearing
*a Oil Groove *b Micro-grooved
*c Oil Groove Depth *d Edge
*e Center *f Large amount of oil leakage at end of groove
*g Smaller amount of oil leakage at end of groove *h Conventional Oil Groove
*i Off-center Oil Groove - -