Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
NM33A0E _59 Vehicle Exterior _067428 LIGHTING (EXT) _0329254 LIGHTING SYSTEM CO CONTROL F

LIGHTING (EXT)  LIGHTING SYSTEM  CONTROL  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Headlight ECU Sub-assembly LH
·

Controls the automatic headlight beam level control system.

·

Detects the vehicle posture and vehicle driving conditions based on the rear height control sensor sub-assembly LH and skid control ECU to control the headlight leveling motor LH.


Headlight ECU Sub-assembly RH Controls the headlight leveling motor RH according to control signals from the headlight ECU sub-assembly LH.
Headlight Leveling Motor LH/RH Moves the headlights vertically and controls the beam axis direction according to control signals from the headlight ECU sub-assembly LH/RH.
Brake Actuator Assembly
·

Skid Control ECU


Transmits the vehicle speed signal to the headlight ECU sub-assembly LH.
Rear Height Control Sensor Sub-assembly LH Detects vehicle movement and transmits a signal to the headlight ECU sub-assembly LH.
Turn Signal Switch
·

Light Control Switch


Outputs a light control switch signal.
Steering Sensor Receives light control switch signal from the turn signal switch and transmits it to the main body ECU (multiplex network body ECU).
Combination Meter Assembly
·

Multi-information Display


Displays a warning message when a malfunction is detected in the automatic headlight beam level control system.
Main Body ECU (Multiplex Network Body ECU) Receives a light control signal and transmits it to the headlight ECU sub-assembly LH.


SYSTEM CONTROL


a.

The headlight ECU sub-assembly LH receives vehicle height change signals sent from the rear height control sensor sub-assembly LH and calculates the changes in the pitch angle of the vehicle. The headlight ECU sub-assembly LH/RH drives the headlight leveling motor LH/RH in accordance with the change.

Control Mode Details
While Stopped If the vehicle attitude is stable for approximately 3 seconds with the headlights on while stopped, the headlight ECU sub-assembly LH/RH operates the headlight leveling motor LH/RH in accordance with the detected change in vehicle attitude.



FUNCTION


a.

The rear height control sensor sub-assembly LH detects the changes in vehicles rear ride height due to cargo loads etc., and operates the headlight leveling motor RH/LH in accordance with the changes, keeping the headlight axes at a constant angle.



FAIL-SAFE


a.

If the headlight ECU sub-assembly detects a malfunction in the automatic headlight beam level control system, the headlight ECU sub-assembly performs the fail-safe operation. For details, refer to the Repair Manual.