Home › Engine / Hybrid System › 6AR-FSE (FUEL) › FUEL SYSTEM › 2018.04–2021.02
NM33A0E _51 Engine / Hybrid System _072442 6AR-FSE FUEL _0351751 FUEL SYSTEM DE DETAILS F

6AR-FSE FUEL  FUEL SYSTEM  DETAILS  FUEL DELIVERY PIPE (FOR DIRECT INJECTION)  


CONSTRUCTION


a.

Cast-iron is used for the fuel delivery pipe with sensor assembly (for direct injection).


b.

A fuel pressure sensor is installed on the fuel delivery pipe with sensor assembly (for direct injection).


c.

A nozzle holder clamp is provided for each area where a fuel injector assembly is installed. This clamp applies a constant spring force to the fuel injector assembly to prevent it from moving when the combustion pressure is applied to the injector while the engine is being started, during which the fuel pressure is low. As a result, the clamp increases the sealing performance of the injector, while reducing vibration and noise.


d.

Metal-to-metal surface seal connections are used for the joint areas of the fuel pressure sensor and high-pressure fuel pipes.

W125003C01
5.188,1.354 4.948,0.677 4.948,0.677 4.729,0.677 true 3.75,1.417 3.51,0.74 3.51,0.74 3.292,0.74 true 4.021,2.333 4.188,2.76 4.188,2.76 4.396,2.76 true 3.24,3.01 3.406,3.438 3.406,3.438 3.615,3.438 true 5.26,2.833 5.427,3.26 5.427,3.26 5.635,3.26 true 4.531,0.573 4.844,0.729 0.313,0.156 10 false *1 3.094,0.635 3.406,0.792 0.313,0.156 10 false *2 5.688,3.156 6,3.313 0.313,0.156 10 false *3 4.448,2.656 4.76,2.813 0.313,0.156 10 false *4 3.646,3.333 3.958,3.49 0.313,0.156 10 false *5
*1 High-pressure Fuel Pipe *2 Fuel Delivery Pipe with Sensor Assembly (for Direct Injection)
*3 Fuel Pressure Sensor (for High Pressure Side) *4 Nozzle Holder Clamp
*5 Direct Fuel Injector Assembly - -