Home › Engine / Hybrid System › 6AR-FSE (EMISSION CONTROL) › EMISSION CONTROL SYSTEM › 2018.04–2021.02
NM33A0E _51 Engine / Hybrid System _072443 6AR-FSE EMISSION CONTROL _0351768 EMISSION CONTROL SYSTEM CO CONTROL F

6AR-FSE EMISSION CONTROL  EMISSION CONTROL SYSTEM  CONTROL  EXHAUST EMISSION CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the exhaust emission control system are as follows:

Component Function
TWC Oxidizes CO and HC in the exhaust gas and deoxidizes NOx at the same time, to purify them into CO2, H2O and N2.
Heated Oxygen Sensor The signal of the air fuel ratio sensor changes abruptly between lean and rich at the stoichiometric air fuel ratio. Located downstream of the catalytic converter.
Air Fuel Ratio Sensor Is used to determine the concentration of oxygen remaining in the exhaust gas. Has a characteristic where its output is proportional to the engine air fuel ratio. Located upstream of the catalytic converter.
ECM Controls the volume of fuel consumed based primarily on the signal from the air fuel ratio sensor, with minor corrections based on the signal from the heated oxygen sensor. This control optimizes the exhaust emissions.