CONSTRUCTION
The valve bodies are heat treated to suppress deformation, allowing oil pump capacity to be reduced.
| *1 | Linear Solenoid Valve SLG | *2 | Linear Solenoid Valve SL1 |
| *3 | Linear Solenoid Valve SL2 | *4 | Linear Solenoid Valve SLU |
| *5 | Linear Solenoid Valve SLP | *6 | Linear Solenoid Valve SLS |
| *1 | Lock-up Clutch | *2 | B1 Brake |
| *3 | C1 Clutch | *4 | Pressure Servo |
| *5 | Primary Pulley | *6 | Secondary Pulley |
| *7 | C2 Clutch | *8 | Valve Body |
| *9 | Linear Solenoid Valve SLP | *10 | Linear Solenoid Valve SLS |
| *11 | Linear Solenoid Valve SLU | *12 | Linear Solenoid Valve SLG |
| *13 | Linear Solenoid Valve SL2 | *14 | Linear Solenoid Valve SL1 |
| *15 | Manual Valve | *16 | Transmission Control ECU |
| *a | NC1 | *b | NT |
| *c | NSS | *d | NOUT |
| *e | Vehicle Speed Control | *f | Belt Clamping Pressure Control |
| *g | Lock-up Control | *h | Pressure Servo Control / Brake Pressure Control |
| *i | Clutch Control | - | - |
OPERATION
Belt Clamping Pressure Control Circuit
To ensure the proper control of the belt clamping pressure necessary for transmitting torque, the system controls the hydraulic pressure applied to the secondary pulley. The transmission valve body assembly is provided with a dedicated hydraulic pressure circuit for belt clamping pressure control. This circuit optimally controls the hydraulic pressure applied to the secondary pulley, thus achieving superior torque transmission performance.
| *1 | Oil Pump Assembly | *2 | Primary Regulator Valve |
| *3 | Linear Solenoid Valve SLS (for Secondary Pulley Control) | *4 | Linear Solenoid Valve SLP (for Primary Pulley Control) |
| *5 | Secondary Sheave Control Valve | *6 | Primary Sheave Control Valve |
| *7 | Primary Pulley | *8 | Secondary Pulley |
Pulley Ratio Control Circuit
Pulley ratio control is performed by controlling the inflow and outflow of the CVT fluid to the primary pulley. Separate hydraulic circuits are provided for acceleration (fluid inflow) and deceleration (fluid outflow) in order to provide fine-tuned control and a high level of reliability.
| *1 | Oil Pump Assembly | *2 | Primary Regulator Valve |
| *3 | Linear Solenoid Valve SLS (for Secondary Pulley Control) | *4 | Linear Solenoid Valve SLP (for Primary Pulley Control) |
| *5 | Secondary Sheave Control Valve | *6 | Primary Sheave Control Valve |
| *7 | Primary Pulley | *8 | Secondary Pulley |
Lock-Up Control
Lock-up control is performed by controlling the oil pressure of the lock-up clutch. The lock up control valve and linear solenoid valve SLU are provided to control the lock-up clutch.
| *1 | Linear Solenoid Valve SLU | *2 | Lock Up Control Valve |
| *3 | Torque Converter Assembly | - | - |
| *a | OFF | *b | ON |