CONSTRUCTION
The No. 1 clearance warning buzzer is installed in the instrument panel. Depending on the detection distance, the sound pattern of the No. 1 clearance warning buzzer will vary.
Sounding of the No. 1 clearance warning buzzers is controlled by the clearance warning ECU assembly.
| Item | Specification | |
|---|---|---|
| No. 1 Clearance Warning Buzzer | Operation Frequency [kHz] | 2.4 +/- 0.04 |
| Sound Pressure Level [dB]* | 80 +/- 6 | |
*: This is the sound pressure level at a position 1 m (3.3 ft.) away from the buzzer itself, not the level where the driver would be sitting (where the sound would actually be heard).
OPERATION
Clearance Warning Buzzer Sounding
If a stationary object is detected at longest range, long-range or medium-range, the buzzer sounding interval changes approximately every 100 mm (3.94 in.) according to the distance from the object, and the clearance warning buzzer sounds.
If a stationary object is detected at short-range or shortest range, the clearance warning buzzer sounds continuously.