Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › from 2021.02
NM33A0E _56 Audio / Visual / Telematics _072317 TELEMATICS _0351274 TELEMATICS SYSTEM(for ERA-GLONASS) CO CONTROL F

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  CONTROL  ERA-GLONASS SERVICE  


FUNCTION OF MAIN COMPONENTS


a.

The main components in the ERA-GLONASS system have the following functions:

Component Function

*1: w/o Stereo Component Amplifier

*2: w/ Stereo Component Amplifier

*3: ERA-GLONASS is available in Russia, Belarus and Kazakhstan.

Map Light Assembly Houses the communication telematics box and manual (SOS) switch.
Major Components of Map Light Assembly Communication Telematics Box
·

Speaker

·

Microphone


·

Houses the microphones and speaker.

·

Receives the user's voice through the microphones.

·

Outputs the operators voice of PSAP through the vehicle speakers.


Manual (SOS) Switch When pressed, allows the driver to connect to and communicate with the PSAP as an emergency assistance button (SOS) service.
Manual (SOS) Switch Indicator Green
·

Turns on when the system is operating normally with in the service area.*3

·

Blinks during a call and turns off when the system is malfunctioning.


Red
·

Illuminates to warn the user when a malfunction occurs in the system.

·

Turns off when the system is operating normally.


Telematics Transceiver (Data Communication Module)
·

Connects to the PSAP and allows the driver to speak with the call center operator when the automatic emergency call service or the manual emergency call service is active.

·

The cellular phone module makes or receives calls.

·

The telematics transceiver (data communication module) receives signals from the GNSS antenna, calculates the position of the vehicle and transmits it to the PSAP.

·

Controls the on/off and blinking actions of the manual (SOS) switch indicator.

·

Dims the manual (SOS) switch indicator when the taillight relay on signal is received.

·

When communicating with PSAP, sends the users voice picked up by the communication telematics box (microphones), and outputs the operators voice through the communication telematics box (speaker).


Mobilephone Battery (Back-up Battery) Is built into the telematics transceiver (data communication module) and supplies power to the telematics transceiver (data communication module) when the automatic emergency call service is activated and the vehicle battery cannot supply power.
Roof Antenna Assembly Telephone Antenna (Main) Is for a cellular phone antenna which is compatible with the transmission and reception of frequency bands of cellular phones. It transmits signals from the telematics transceiver (data communication module) and receives signals from the call center.
GNSS Antenna Receives the signals from GNSS satellites and transmits these signals to the telematics transceiver (data communication module).
Navigation Antenna Assembly Telephone Antenna (Sub) Is a cellular phone antenna which is compatible with reception of frequency bands of cellular phones. It receives signals from the emergency call center. It also functions as an antenna for transmitting when there is a malfunction in the telephone antenna (main).
Airbag Sensor Assembly Sends an activation signal to the telematics transceiver (data communication module) when the airbags deploy. (An automatic emergency call service is made.)
Main Body ECU (Multiplex Network Body ECU) Sends the taillight relay on signal to the telematics transceiver (data communication module).
Radio and Display Receiver Assembly*1 Receives the mute signal from the telematics transceiver (data communication module) to mute any audio sound.
Stereo Component Amplifier Assembly*2 Receives the mute signal from the telematics transceiver (data communication module) to mute any audio sound.
DLC3 Allows system diagnosis to be performed when Global TechStream (GTS).



FUNCTION


a.

Automatic Emergency Call Service

·

If any of the airbags are deployed due to a serious collision or the vehicle rolls over, the telematics transceiver receives the deployment signal from the airbag ECU assembly. After receiving the deployment signal, the telematics transceiver automatically makes an emergency call and transmits the vehicle location and user information to the PSAP closest to the vehicle.

·

The system is then automatically connected to a PSAP and the user can talk to a PSAP operator. The PSAP operator contacts the emergency services when the user is unable to answer.

Y218458C02
1.573,1.677 1.885,1.875 0.313,0.198 10 false *a 1.583,3.406 1.896,3.604 0.313,0.198 10 false *b 3.99,1.49 4.302,1.688 0.313,0.198 10 false *c 5.792,1.469 6.104,1.667 0.313,0.198 10 false *d
*a Airbag Deployment or Collision Detection *b Rollover Detection
*c Public Safety Answering Point (PSAP) *d Ambulance




b.

Manual Emergency Call Service

·

By pushing the manual (SOS) switch during an on-road emergency, the telematics transceiver transmits the vehicle location and user information, and calls to the PSAP closest to the vehicle.

·

The PSAP operator determines the level of the emergency based on the vehicle location and from the conversation with the user, and contacts the emergency services if necessary.

Y178730C01
1.948,1.365 2.26,1.563 0.313,0.198 10 false *1 4.906,1.354 5.219,1.552 0.313,0.198 10 false *a
*1 Mayday Switch Assembly (Manual (SOS) Switch) - -
*a Public Safety Answering Point (PSAP) - -





DIAGNOSIS


a.

If there is a malfunction in the system, the telematics transceiver stores Diagnostic Trouble Codes (DTCs) in its memory. For details, refer to the Repair Manual.