CONSTRUCTION
Sound Absorption and Insulation Structure around Engine Compartment
A hood insulators provided below the hood sub-assembly to suppress engine drive noise which penetrates the cabin and provide excellent quietness.
A front fender seal and front side air guide sub-assembly are used in the front fender to reduce the noise which travels through the fender toward the cabin.
| *1 | Hood Insulator | *2 | Front Fender Seal |
| *3 | Front Side Air Guide Sub-assembly | - | - |
| *a | A - A Cross Section | *b | The illustrations shown are examples only. |
The dash panel insulator inner is provided in the cabin side, minimizing penetration of engine noise and road noise into the cabin.
| *1 | Dash Panel Insulator Inner | - | - |
| *a | Sectional Image | *b | Soft Felt |
| *c | Olefin Sheet | *d | The illustrations shown are examples only. |
|
Noise | - | - |
Sealing Material
Foamed materials, damping foamed materials and sealant are optimally placed in the front header panel, side member opening and rear wheel house to suppress wind noise and road noise which enter the cabin.
| *1 | Front Header Panel | *2 | Rear Wheel House |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
| *e | E - E Cross Section | *f | F - F Cross Section |
| *g | G - G Cross Section | *h | The illustrations shown are examples only. |
|
Foamed Material |
|
Damping Foamed Material |
Floor Silencer
The floor silencer (applied damping materials) optimal thickness varies by the area, is lightweight and provides excellent quietness. These characteristics allow the floor silencer to reduce road and engine noise which enters the cabin.
| *a | The illustrations shown are examples only. | - | - |
|
Applied Damping Materials | - | - |