Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319006 CAMSHAFT OIL CONTROL VALVE G

2AR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.


b.

Check the operation.

i.
A411324C01
0.771,1.146 1.052,1.625 1.052,1.625 1.219,1.625 true 2.75,0.052 3.063,0.208 0.313,0.156 10 false *a 0.5,0.469 0.813,0.625 0.313,0.156 10 false *b 0.469,1.5 0.781,1.656 0.313,0.156 10 false *c 1.26,1.552 1.573,1.708 0.313,0.156 10 false *d
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)
*b When Battery Voltage Applied
*c When Battery Voltage Cut Off
*d Spool Valve


Connect a battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the spool valve.

OK:
Condition Specified Condition
Battery voltage applied Valve moves in left arrow direction shown in illustration
Battery voltage cut off Valve moves in right arrow direction shown in illustration


NOTICE:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks in the intake side camshaft timing oil control valve assembly will cause the intake camshaft to advance. Minor pressure leaks in the exhaust side camshaft timing oil control valve assembly will cause the exhaust camshaft to retard. The inappropriate camshaft timing that results from these leaks will cause a DTC to be stored.


If the result is not as specified, replace the camshaft timing oil control valve assembly.