Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319006 CAMSHAFT OIL CONTROL VALVE G

2AR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Turn the A/C switch on.


e.

Inspect the camshaft timing oil control valve assembly (for intake side).

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank1).

Powertrain > Engine and ECT > Active Test
Tester Display
Control the VVT Linear (Bank1)
50004 234 32

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly using the GTS.

Standard Condition:
GTS Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

Refer to "Data List / Active Test" [VVT OCV Duty #1 and VVT Change Angle #1].

Click hereEngine / Hybrid System>2AR-FE (ENGINE CONTROL)>SFI SYSTEM>DATA LIST / ACTIVE TEST

·

If DTCs are stored after the Active Test, clear the DTCs.



If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.



f.

Inspect the camshaft timing oil control valve assembly (for exhaust side).

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Exhaust Linear (Bank1).

Powertrain > Engine and ECT > Active Test
Tester Display
Control the VVT Exhaust Linear (Bank1)
50004 234 87

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly using the GTS.

Standard Condition:
GTS Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

Refer to "Data List / Active Test" [VVT Ex OCV Duty #1 and VVT Ex Chg Angle #1].

Click hereEngine / Hybrid System>2AR-FE (ENGINE CONTROL)>SFI SYSTEM>DATA LIST / ACTIVE TEST

·

If DTCs are stored after the Active Test, clear the DTCs.



If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.