Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319006 CAMSHAFT OIL CONTROL VALVE A

2AR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSTALLATION  


PROCEDURE

Hide 11101J 1.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side)

a.

Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly.

NOTICE:

Do not damage the O-ring.



b.

Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft timing oil control valve assembly has been struck or dropped, replace it.

·

Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft timing oil control valve assembly.




c.

Connect the camshaft timing oil control valve assembly connector.


Hide 11101J 2.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side)

a.

Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly.

NOTICE:

Do not damage the O-ring.



b.

Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft timing oil control valve assembly has been struck or dropped, replace it.

·

Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft timing oil control valve assembly.




c.

Connect the camshaft timing oil control valve assembly connector.


Hide 3.INSPECT FOR ENGINE OIL LEAK

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY