Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › ECM › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319008 ECM A

2AR-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89668 1.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89667E 2.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89661 3.INSTALL ECM

a.

Install the ECM with the nut and 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If the ECM has been struck or dropped, replace it.



b.
A405021

Connect the 2 ECM connectors and rotate the 2 levers to lock them.

NOTICE:
·

When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water and other foreign matter.

·

Be sure to securely connect the ECM connectors.




Hide 17700 4.INSTALL AIR CLEANER ASSEMBLY

a.
A405019C01
0.927,1.938 1.24,2.094 0.313,0.156 10 false *a 1.594,2.438 1.906,2.594 0.313,0.156 10 false *b
*a Up
*b 13 to 19 mm (0.512 to 0.748 in.)


Engage the 3 pins to install the air cleaner assembly.


b.

Install the air cleaner hose assembly to the air cleaner assembly.


c.

Tighten the hose clamp in the position shown in the illustration.


d.

Engage the 3 wire harness clamps.


e.

Connect the mass air flow meter sub-assembly connector.


Hide 17750A 5.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 53295E 6.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL