Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319010 CAMSHAFT POSITION SENSOR A

2AR-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A231950C03
1.708,0.51 1.427,0.198 1.427,0.198 1.167,0.198 false 0.979,0.115 1.292,0.313 0.313,0.198 10 false *a
*a O-ring


Apply a light coat of engine oil to the O-ring of the camshaft position sensor.


b.

Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.




c.

Connect the camshaft position sensor connector.


Hide 11102A 2.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.
A231950C03
1.708,0.51 1.427,0.198 1.427,0.198 1.167,0.198 false 0.979,0.115 1.292,0.313 0.313,0.198 10 false *a
*a O-ring


Apply a light coat of engine oil to the O-ring of the camshaft position sensor.


b.

Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.




c.

Connect the camshaft position sensor connector.


Hide 3.INSPECT FOR ENGINE OIL LEAK

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY