Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319011 CRANKSHAFT POSITION SENSOR A

2AR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.




c.

Connect the crankshaft position sensor connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK