Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › KNOCK SENSOR › 2017.09–2018.04
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319014 KNOCK SENSOR A

2AR-FE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the knock control sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Replacement of knock control sensor

·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 89615 2.REMOVE KNOCK CONTROL SENSOR

a.
A342010

Disconnect the knock control sensor connector.


b.

Remove the bolt and knock control sensor from the cylinder block sub-assembly.

NOTICE:

If the knock control sensor has been struck or dropped, replace it.