Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › HEATED OXYGEN SENSOR › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319016 HEATED OXYGEN SENSOR G

2AR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR

a.
A196092C02
1.396,1.313 1.115,1.115 1.115,1.115 0.969,1.115 true 1.375,1.677 1.083,1.875 1.083,1.875 0.927,1.875 true 2.51,1.073 2.333,1.073 2.333,1.073 2.042,1.344 true 0.156,0.125 0.51,0.365 0.354,0.24 10 *a 0.74,1.021 1.01,1.219 0.271,0.198 10 +B 0.729,1.781 1.063,2.021 0.333,0.24 10 E2 2.583,0.979 3.042,1.219 0.458,0.24 10 HT1B
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B) 20°C (68°F) 9 to 14 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.