Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT › 2017.09–2017.12
RM33A0E _58 Vehicle Interior _065387 HEATING / AIR CONDITIONING _0319107 BLOWER UNIT A

HEATING / AIR CONDITIONING  BLOWER UNIT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Steering sensor
·

Steering angle neutral point (Initialize parking assist monitor system)

·

Steering angle setting


Parking assist monitor system (Click here)for Initialization
(Click here)for Calibration

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:

Before removing the blower assembly, set the air conditioning to recirculation mode.


PROCEDURE

Hide 1.REMOVE AIR CONDITIONER UNIT ASSEMBLY

Hide 87130D 3.REMOVE BLOWER ASSEMBLY

a.

for LHD:

i.
E377127

Disconnect the connector.


ii.

Disengage each guide.


iii.
E372595

Remove the 2 screws.


iv.

Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.



b.

for RHD:

i.
E372599C01
0.167,2.167 0.417,2.417 0.25,0.25 12 true *A 1.833,2.167 2.083,2.417 0.25,0.25 12 true *B
*A for 1-tier Type
*B for 2-tier Type


Disconnect the connector.


ii.

Disengage each guide.


iii.
E372600

Remove the 2 screws.


iv.

Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.