This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
44777
1.DISCONNECT NO. 1 VACUUM HOSE CONNECTOR
| *a | Retainer |
|
Pinch |
|
Pull off |
Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.
Be sure to disconnect the No. 1 vacuum hose connector by hand.
82121
2.SEPARATE ENGINE WIRE
Disengage the 2 clamps to separate the engine wire.
29300
3.REMOVE VACUUM PUMP ASSEMBLY
Using an 8 mm socket wrench, remove the 3 bolts and vacuum pump assembly from the engine assembly.
Remove the No. 1 vacuum pump O-ring from the vacuum pump assembly.