Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD)
RM33A0E _54 Brake _065366 BRAKE SYSTEM (OTHER) _0319140 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  REMOVAL  


PROCEDURE

Hide 55708 1.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

Hide 53607A 2.REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY

Hide 3.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 4.DISCONNECT BRAKE LINE

a.
C380304

Disconnect the connector from the brake master cylinder sub-assembly.


b.

Separate the wire harness from the brake master cylinder sub-assembly.


c.
C380305

Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.

NOTICE:
·

Do not damage or deform the brake lines.

·

Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.




Hide 67913 5.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62111A 6.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 55606 7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 84340 8.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 47264A 9.REMOVE PUSH ROD PIN

a.
C380297

Remove the clip and push rod pin.


Hide 10.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C380298

Disengage the clamp to separate the wire harness from the brake pedal support assembly.


b.
C380299

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C380300C01
0,0 0,0 false
V100135

Nut
V100136

Clip


Remove the 2 clips.


d.

Remove the 4 nuts and push the brake booster assembly toward the engine compartment.

NOTICE:
·

Do not apply excessive force to the brake lines.

·

Do not apply excessive force to the wire harness.




e.

Remove the brake pedal support assembly while avoiding the stud bolts of the brake booster assembly and brake booster support base.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly.



Hide 47101A 11.REMOVE BRAKE PEDAL RETURN SPRING

a.
C380302

Remove the brake pedal return spring from the brake pedal support assembly.


Hide 84345 12.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
C380301

Disengage the 2 claws and remove the stop light switch mounting adjuster.


Hide 47121 13.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.