Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for A25A-FKS)
RM33A0E _52 Drivetrain _065358 DRIVE SHAFT / PROPELLER SHAFT _0319275 FRONT DRIVE SHAFT ASSEMBLY(for A25A-FKS) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for A25A-FKS)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C211744

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C375241C01
0.167,0.167 0.542,0.406 0.375,0.24 10 false *A 0.115,1.385 0.49,1.625 0.375,0.24 10 false *B 1.479,0.917 1.635,1.115 0.156,0.198 10 false A 0.688,0.667 0.948,0.979 0.26,0.313 10 false B 1.438,2.875 1.594,3.073 0.156,0.198 10 false A 0.25,2.635 0.51,2.948 0.26,0.313 10 false B
*A for LH Side
*B for RH Side


Check whether the drive shaft dimension (A) and (B) are within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


Dimension (A):
for LH Side 586.2 to 596.2 mm (1.93 to 1.95 ft.)
for RH Side 910.0 to 920.0 mm (2.99 to 3.01 ft.)


Dimension (B):
for LH Side 88.2 mm (3.47 in.)
for RH Side 96.8 to 97.8 mm (3.82 to 3.85 in.)