Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 2AR-FE, 6AR-FSE) › 2017.09–2021.02
RM33A0E _52 Drivetrain _065358 DRIVE SHAFT / PROPELLER SHAFT _0319282 FRONT DRIVE SHAFT ASSEMBLY(for 2AR-FE, 6AR-FSE) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 2AR-FE, 6AR-FSE)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C091598

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C240884C05
0.115,1.656 0.969,1.917 0.854,0.26 10 false *B 0.115,0.052 0.74,0.375 0.625,0.323 10 false *A 1.427,1.385 1.698,1.635 0.271,0.25 10 false A 1.448,2.938 1.719,3.198 0.271,0.26 10 false A
*A for LH Side
*B for RH Side


Check whether the drive shaft dimension (A) is within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


Dimension (A):
for LH Side 591.2 mm (1.94 ft.)
for RH Side 910.0 mm (2.98 ft.)