23070
1.INSTALL FUEL MAIN VALVE ASSEMBLY (for High Pressure)
Apply gasoline to a new O-ring. Then install the O-ring to the fuel main valve assembly.
| *1 | Fuel Main Valve Assembly |
| *a | Mesh |
| *b | Mini-clip |
| *c | No Clearance |
Make sure that there is no clearance between the fuel main valve assembly and mesh.
Install the fuel main valve assembly to the fuel filter.
Make sure that the O-ring is not cut or pinched during installation.
Install the clip to the fuel filter.
23070
2.INSTALL FUEL MAIN VALVE ASSEMBLY (for Low Pressure)
Apply gasoline to 2 new O-rings. Then install the O-rings to the fuel main valve assembly.
Install the fuel main valve assembly to the fuel filter.
Make sure that the O-rings are not cut or pinched during installation.
Install the clip to the fuel filter.
3.INSTALL FUEL FILTER
Apply gasoline to a new O-ring. Then install the O-ring to the fuel sub-tank.
Install the fuel filter to the fuel sub-tank as shown in the illustration.
Make sure that the O-ring is not cut or pinched during installation.
Engage the 3 claws.
Securely engage the claws.
Engage the clamp to connect the tube to the fuel filter.
83320
4.INSTALL FUEL SENDER GAUGE ASSEMBLY
77020A
5.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY