The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel filter removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
83320
2.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
3.REMOVE FUEL PUMP
23070
4.REMOVE FUEL MAIN VALVE ASSEMBLY
77174
5.REMOVE NO. 1 FUEL SUCTION SUPPORT
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.
77174
6.INSTALL NO. 1 FUEL SUCTION SUPPORT
Engage the 2 claws to install the No. 1 fuel suction support to the fuel filter.
23070
7.INSTALL FUEL MAIN VALVE ASSEMBLY
23221
8.INSTALL FUEL PUMP
83320
9.INSTALL FUEL SENDER GAUGE ASSEMBLY
10.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY