Home › Engine / Hybrid System › 2GR-FKS (FUEL) › FUEL PRESSURE SENSOR (for High Pressure)
RM33A0E _51 Engine / Hybrid System _065334 2GR-FKS FUEL _0319419 FUEL PRESSURE SENSOR(for High Pressure) G

2GR-FKS FUEL  FUEL PRESSURE SENSOR(for High Pressure)  INSPECTION  


PROCEDURE

Hide 23860 1.INSPECT FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH)

NOTICE:
·

Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.

·

If the fuel pressure sensor is removed, replace the fuel pressure sensor (fuel delivery pipe with sensor assembly LH) with a new one.



a.

Check the fuel pressure sensor output voltage.

i.
A330384C02
1.583,0.771 2,0.333 2,0.333 2.167,0.333 true 1.427,0.771 1.042,0.313 1.042,0.313 0.875,0.313 true 0.167,0.167 0.479,0.323 0.313,0.156 10 false *a 1.688,1.844 2,2 0.313,0.156 10 false *b 2.208,0.26 2.521,0.458 0.313,0.198 10 false VC 0.688,0.24 1,0.438 0.313,0.198 10 false E2
*a Component without harness connected
(Fuel Pressure Sensor)
*b Voltage Applied between Terminals


Apply 5 V between terminals 1 (VC) and 2 (E2).

NOTICE:
·

Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (VC) or 2 (E2).



HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.



ii.
A326513C04
1.615,1.156 1.313,1.667 1.313,1.667 1.313,1.833 true 1.729,1.167 1.99,1.667 1.99,1.667 1.99,1.833 true 0.125,0.125 0.438,0.281 0.313,0.156 10 false *a 1.948,1.865 2.26,2.063 0.313,0.198 10 false E2 1.24,1.865 1.552,2.063 0.313,0.198 10 false PR
*a Component without harness connected
(Fuel Pressure Sensor)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
3 (PR) - 2 (E2) Pressure not applied to fuel pressure sensor Approximately 0.4 to 0.6 V*


*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the fuel pressure sensor (fuel delivery pipe with sensor assembly LH).