Home › Engine / Hybrid System › 2GR-FKS (FUEL) › FUEL SENDER GAUGE ASSEMBLY
RM33A0E _51 Engine / Hybrid System _065334 2GR-FKS FUEL _0319423 FUEL SENDER GAUGE ASSEMBLY G

2GR-FKS FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

CAUTION:

Perform the inspection in a well-ventilated area.

Do not perform the inspection near an open flame.


a.

Check that the float moves smoothly between F and E.


b.

Check the fuel sender gauge assembly voltage.

i.
A315527C01
0.063,0.063 0.375,0.219 0.313,0.156 10 false *a 1.646,2.49 1.958,2.646 0.313,0.156 10 false *b
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage Applied between Terminals


Apply 5 V between terminals 2 and 3.

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 2 or 3.



HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.



ii.
A401825C01
0.75,0.25 2.677,1.688 1.927,1.438 0.479,2.583 0.885,2.583 true 0.688,4.177 1.229,4.177 true 0.802,0.281 1.115,0.438 0.313,0.156 10 false *a 0.365,2.5 0.521,2.698 0.156,0.198 10 false F 0.563,4.094 0.719,4.292 0.156,0.198 10 false E
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Float Level Specified Condition
1 - 2 F 4.255 to 4.605 V*
Between F and E 0.345 to 4.605 V* (Gradually changes)
E 0.345 to 0.695 V*


*: The output voltage changes depending on the voltage applied to the terminals.

Output voltage (F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

Output voltage (E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)

If the result is not as specified, replace the fuel sender gauge assembly.