w/ Smart Key System:
Before replacing the steering lock actuator assembly, refer to Service Bulletin.
1.REMOVE UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)
Secure the steering column assembly in a vise between aluminum plates.
Do not overtighten the vise.
Using a drill, drill a hole in the 2 steering lock set bolts and insert a screw extractor.
Using the screw extractor, remove the 2 steering lock set bolts, upper steering column clamp and upper steering column bracket with switch assembly.
45020B
2.REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)
Perform the same procedure as for the upper steering column bracket with switch assembly (w/o Smart Key System).
3.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)
| *a | LOCK |
| *b | ACC |
|
Push |
|
Pull |
Turn the ignition switch to ACC.
Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly, as shown in the illustration, and pull out the ignition switch lock cylinder assembly.
84052
4.REMOVE UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)
| *a | Center Part |
Remove the un-lock warning switch assembly by pushing up the center part and releasing the 2 claws.
Slide the un-lock warning switch assembly in the direction shown by the arrow in the illustration to remove it.
84450
5.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)
Disengage the 2 claws and remove the ignition or starter switch assembly from the upper steering column bracket assembly.