Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) › 2017.09–2022.01
RM33A0E _55 Steering _065371 STEERING COLUMN _0319591 STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column)  REASSEMBLY  


PROCEDURE

Hide 84450 1.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

a.

Engage the 2 claws to install the ignition or starter switch assembly onto the upper steering column bracket assembly.


Hide 84052 2.INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C378456

Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly.

HINT:

Slide the un-lock warning switch assembly, in the direction shown by the arrow in the illustration, to install it.



Hide 3.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

a.
C375248C01
0.667,0.906 0.979,1.063 0.313,0.156 10 false *a 0.458,0.521 0.771,0.677 0.313,0.156 10 false *b
*a LOCK
*b ACC


Turn the ignition switch to ACC.


b.

Install the ignition switch lock cylinder assembly to the upper steering column bracket assembly.


c.

Make sure that the ignition switch lock cylinder assembly is securely installed into the upper steering column bracket assembly.


Hide 4.INSTALL UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)

a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Temporarily install the upper steering column bracket with switch assembly and upper steering column clamp with 2 new steering lock set bolts.


c.
C375249

Tighten the 2 steering lock set bolts until the bolt head breaks off.


Hide 45020B 5.INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

NOTICE:

When replacing the steering lock actuator assembly, perform registration.


HINT:

Perform the same procedure as for the upper steering column bracket with switch assembly (w/o Smart Key System).