Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM33A0E _52 Drivetrain _065359 AXLE AND DIFFERENTIAL _0319632 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 890C0A 2.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

a.
C371415

Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

NOTICE:
·

Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.

·

Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.




b.
C376651C02
1.573,1.771 1.865,1.771 1.865,1.771 1.865,1.469 true 1.333,1.688 1.563,1.865 0.229,0.177 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.

NOTICE:

Be careful not to damage the rear axle hub and bearing assembly or connector cover.



Hide 3.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42431 4.REMOVE REAR DISC

Hide 42450B 5.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C376652

Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.