Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM33A0E _52 Drivetrain _065359 AXLE AND DIFFERENTIAL _0319632 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 890C0A 2.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Hide 3.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42431 4.REMOVE REAR DISC

Hide 5.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C381589

Using a dial indicator with magnetic base, check for looseness near the center of the rear axle hub.

Maximum Looseness:

0.05 mm (0.00196 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



HINT:

If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.



Hide 6.INSPECT REAR AXLE HUB RUNOUT

a.
C381590

Using a dial indicator with magnetic base, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.

Maximum Runout:

0.05 mm (0.00196 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolts.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



HINT:

If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.



Hide 42431 7.INSTALL REAR DISC

Hide 8.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 890C0A 9.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Hide 10.INSTALL REAR WHEEL