Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING
RM33A0E _59 Vehicle Exterior _065397 EXTERIOR PANELS / TRIM _0319672 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75552H 1.REMOVE ROOF DRIP SIDE FINISH MOULDING

a.

Apply protective tape around the roof drip side finish moulding as shown in the illustration.

B470936C01
0,0 0,0 false
V100155

Protective Tape - -



b.

Using a moulding remover, disengage the 2 clips and remove the roof drip side finish moulding.

B470937

NOTICE:
·

Do not remove the roof drip side finish moulding clips.

·

If a roof drip side finish moulding clip is damaged or falls off, replace it with a new one.