Home › General › MAINTENANCE › REAR BRAKE FLEXIBLE HOSE
RM33A0E _V1 General _065356 MAINTENANCE _0319690 REAR BRAKE FLEXIBLE HOSE A

MAINTENANCE  REAR BRAKE FLEXIBLE HOSE  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

If both left and right rear flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47319F 3.REMOVE REAR FLEXIBLE HOSE

a.
C371414

Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.


b.
C379270

Remove the bolt and separate the rear flexible hose from the rear flexible hose bracket.


c.

Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.




d.

Remove the clip and rear flexible hose from the vehicle body.