16361A
1.INSTALL V-RIBBED BELT
When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.
| *1 | Crankshaft Pulley Assembly |
| *2 | Generator Assembly |
| *3 | Compressor Assembly With Pulley |
Set the V-ribbed belt onto each pulley as shown in the illustration.
Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.
| *a | Correct |
| *b | Incorrect |
After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.
2.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51441
3.INSTALL NO. 1 ENGINE UNDER COVER
53852K
4.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
53851M
5.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH